Operating And Installation Guide 1

Selecting additional settings
38
 Now touch the or sensors to
select:
0:keypad tone off; door alarm off
1:keypad tone off; door alarm on
(after 4minutes)
2:keypad tone off; door alarm on
(after 2minutes)
3:keypad tone on; door alarm on
(after 2minutes)
 Touch the OK sensor to confirm the
selection.
The selected setting is applied; the
symbol flashes.
 Touch the settings sensor to exit
settings mode.
If you do not do this, the appliance
electronics will exit settings mode
automatically after approximately
1minute.
Display brightness
You can adjust the brightness of the
display to suit the ambient light
conditions in the room.
The display brightness can be adjusted
incrementally from1to3. The factory
default setting is 3(maximum
brightness).
Changing the brightness of the
display
 Touch the settings sensor.
All symbols available for selection will
appear in the display and the 
symbol flashes.
 Touch the sensors for setting the
temperature ( or ) repeatedly until
the symbol flashes in the display.
 Touch the OK sensor to confirm your
selection.
The last selected setting flashes and
the  symbol lights up in the display.