Operating and Installation Instructions

Installation
^
Push the appliance into the niche
until the covers of the fixing brackets
touch the front edge of the side walls
of the housing unit.
–
n With 16 mm thick walls:
The spacers should touch the front
edge of the top and bottom of the
side walls of the housing unit.
–
o With 19 mm thick furniture
walls:
The front edges of the hinges are
flush with the front edge of the
housing unit.
^
Make sure that the covers of the top
and bottom fixing brackets lie flush
with the front edges of the housing
unit side walls.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.
On furniture with door fittings (e.g.
stubs, seals etc.) the dimension of
these must be taken into account when
making sure there is a gap all round of
42 mm.
^ Pull the appliance forwards by the
appropriate dimension.
The hinges now protrude by the
appropriate dimension.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
^ p Align the appliance on both sides
by altering the adjustable feet using
the spanner supplied.
If the all round gap of 42 mm is not
maintained between the appliance
housing and the front edge of the
housing unit side wall, the door may
not shut properly.
This could lead to a build-up of ice,
condensation and other operational
faults, resulting in an increase in
energy consumption.
Installation
98