Operating and Installation Instructions

Rinsing the ice cube maker
Rinse out the ice cube maker and
the water pipes
– before using for the first time,
– when the ice cube maker has not
been used for quite a while,
– regularly (at least once a month) if
it is constantly being used, to
remove any ice residues and
therefore avoid an blockages in the
water pipes, and
– before switching the ice cube
maker off for an extended period of
time.
After selecting "Rinse the ice cube
maker", the ice cube maker b and the
water inlet pipes will automatically be
rinsed.
The ice cube tray will turn to the
cleaning position so that it can be
cleaned by hand.
The water is collected in the ice cube
tray drawer a.
Ensure the ice cube drawer is empty
before selecting "Rinse the ice cube
maker". The water will otherwise flow
onto the contents of the drawer.
"Rinse the ice cube maker" can only
be selected when the ice cube
maker is switched on.
^ Touch the settings sensor.
All selectable symbols appear in the
display and the 0 flashes.
^ Touch the sensors for setting the
temperature (X or Y) repeatedly until
the symbol for the ice cube maker ®
flashes in the display.
^ Touch the OK sensor to confirm your
selection.
^
The required setting can be selected
by touching the X and Y sensors:
0: Ice cube maker is switched off
1: Ice cube maker is switched on
2: Set the water quantity
3: Set cleaning position for the ice
cube tray
4: Rinse the ice cube maker
Cleaning and care
58