Operating and Installation Instructions

If you require a large quantity of ice
cubes,
^
replace the full ice cube drawer with
the drawer beside it on the right.
The ice cube maker will begin to
produce ice cubes again as soon as
this new drawer has been placed in
position and closed properly.
Changing the size of the ice cubes
The size of the ice cubes depends on
the quantity of water being taken in.
You are able to set this quantity
according to your wishes.
Setting the water quantity
The quantity of water necessary for
making ice cubes can be set. A
medium quantity is set at the factory
(E3).
The setting can only be selected if
the ice cube maker is switched on.
^
Touch the settings sensor.
All selectable symbols appear in the
display and the 0 flashes.
^
Touch the sensors for setting the
temperature (X or Y) repeatedly until
the symbol for the ice cube maker ®
flashes in the display.
^
Touch the OK sensor to confirm your
selection.
^
The X and Y sensors can be used to
set whether the water quantity is to
be changed:
0: Ice cube maker is switched off
1: Ice cube maker is switched on
2: Set the water quantity
3: Ice cube tray cleaning position
4: Rinse the ice cube maker
^
Touch the OK sensor to confirm your
selection.
^
Touch the X and Y sensors to set the
required water quantity (E1 to E8):
E1: small quantity
E8: large quantity
^ Touch the OK sensor to confirm your
selection.
The selected setting will be adopted.
^ Touch the settings sensor to leave
settings mode,
or
^ close the appliance door.
The electronics will otherwise switch to
normal operation after one minute.
Making ice cubes
54