Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Specifications for the plumbed water connection
- Installation dimensions
- Dimensions of cabinet fronts
- Building in the appliance
- Before starting...
- Tools required
- Weight of cabinet fronts
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Preparing the cabinet fronts
- Securing and aligning the cabinet front
- Mounting the retaining brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Securing the toe-kick ventilation grille and toe-kick cover
- Limiting the opening angle of the appliance door
- Water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
Frequently Asked Questions
123
Problem Possible cause and solution
The compressor comes
on less and less often
and for shorter periods
of time. The tempera-
ture in the appliance
rises.
This is not a fault. The temperature setting is too
high.
Correct the temperature setting.
Check the temperature again after 24hours.
The food begins to thaw.
The ambient temperature is too low for this appli-
ance.
If the ambient temperature is too low, the compres-
sor will run less frequently. This may cause the
freezer to become too warm.
See the information in the section on “Installation –
Installation location”.
Increase the ambient temperature.
The compressor runs
continuously.
Not a fault. To save energy, the compressor runs at
a lower speed when less cooling is required. This
increases the compressor run time.
Food has frozen to-
gether or to the wall.
The food packaging was not dry when loaded in the
freezer.
Use a blunt instrument (such as a spoon handle) to
carefully pry them apart.
An alarm sounds. The appliance doors have been open for longer than
approx. 2minutes.
Close the appliance doors.
No alarm sounds de-
spite the appliance door
being open.
You have switched off the audible signal.
Switch the audible signal back on using Settings
mode.
The Sabbath Mode function is switched on: the tem-
perature display is dark and the symbol is shown
on the display.
You can switch off Sabbath mode at any time (see
“Selecting additional settings – Switching Sabbath
Mode on or off”).
The appliance door
cannot be opened.
The Pull2OpenDoor Assistant is switched on but the
appliance has a handle-free cabinet front.
For handle-free cabinet fronts, switch on the
Push2OpenDoor Assistant (see “Switching on the
Door Assistant” in “Selecting additional settings”).