Operating & Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Specifications for the plumbed water connection
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Securing the toe-kick board and cover
- Aligning the appliance doors
- Limiting the opening angle of the appliance door
- Water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
Cleaning and care
105
6.
Turn the cap of the filter cartridge
clockwise until it is in the horizontal
position 6.
Risk of damage caused by water
rushing out.
If the filter cartridge is not inserted
correctly, there is a risk of water
leaking out of the appliance.
When inserting the filter cartridge, be
sure to turn it as far as the marker.
Once the IntensiveClear 2.0 mesh filter
has been cleaned, the Water Filter Display
must be reset using Settings
mode on the display (see “Selecting
additional settings – Resetting the Water
Filter Display ”).
Replacing the Active AirClean
filters
The Active AirClean filters in the refrig-
erator section need to be replaced ap-
prox. every 6months.
Change Active AirClean Filter will appear
on the display.
Confirm the message with OK.
To remove the holder for the Active
AirClean filters, press against the re-
tainers on both sides of the holder
from the rear and pull the holder
downwards diagonally from the
frame.
Remove the used Active AirClean fil-
ters and place the new Active Air-
Clean filters with the surrounding
edge pointing downwards in the
holder.
To replace the holder, press against
the retainers on both sides of the
holder from the rear and clamp it into
the gap on the frame from below.