Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Specifications for the plumbed water connection
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Securing the toe-kick board and cover
- Aligning the appliance doors
- Limiting the opening angle of the appliance door
- Water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
Selecting additional settings
72
Switching on the Water Filter Display
If the Water Filter Display has been
switched off once, it must be switched
on again if required.
In Settings mode , use the and
sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
Use the and sensor controls to
select On and select OK to confirm
your selection.
The Water Filter Display has been
switched on.
Switching off the Water Filter Display
Risk to health due to contami-
nated water.
If the IntensiveClear 2.0 charcoal fil-
ter is not replaced on a regular basis,
it may become contaminated.
Only switch off the Water Filter Display
if an external water filter has been at-
tached to your household water sup-
ply in place of the IntensiveClear 2.0
charcoal filter. In this case, you
should also use an IntensiveClear 2.0
mesh filter in place of the Intensive-
Clear 2.0 charcoal filter (see “Acces-
sories – Optional accessories”).
In Settings mode , use the and
sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
Use the and sensor controls to
select Off and select OK to confirm
your selection.
The Water Filter Display has been
switched off.
Resetting the Water Filter Display
After you have replaced or cleaned the
water filter, you must reset the Water Fil-
ter Display so that it can be displayed
again after 6months.
If you do not reset the display, it ap-
pears again and again.
In Settings mode , use the and
sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
Use the and sensor controls to
select Reset and select OK to confirm
your selection.
The Replace the water filter message dis-
appears from the display.
The Water Filter Display has been acti-
vated for the next time the water filter
requires cleaning or replacing.