Operating Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
 - Caring for the environment
 - Installation
- Installation location
 - Installation notes
 - Specifications for the plumbed water connection
 - Installation dimensions
 - Building in the appliance
- Before starting...
 - Tools required
 - Aligning the installation niche
 - Checking the installation niche
 - Before installation
 - Preparing the installation niche
 - Pushing the appliance into the niche
 - Aligning the refrigeration appliance
 - Securing the appliance in the niche
 - Securing the toe-kick board and cover
 - Aligning the appliance doors
 - Limiting the opening angle of the appliance door
 
 - Water connection
 - Electrical connection
 
 - Saving energy
 - Guide to the appliance
 - Accessories
 - Before first use
 - Switching on and off
 - Selecting additional settings
 - The correct temperature
 - Using Automatic SuperCool and SuperFreeze
 - Temperature and door alarm
 - Adjusting the interior fittings
 - Storing food in the refrigerator section
 - Storing food in the MasterFresh zone
 - Freezing and storing food
 - Making ice cubes
 - Automatic defrosting
 - Cleaning and care
 - Water filter
 - Frequently Asked Questions
 - Causes of noises
 - Customer Service
 - Declaration of conformity
 - Copyrights and licenses
 
 
Frequently Asked Questions
115
Problem Possible cause and solution
The compressor comes
on less and less often
and for shorter periods
of time. The tempera-
ture in the appliance
rises.
This is not a fault. The temperature setting is too
high.
 Correct the temperature setting.
 Check the temperature again after 24hours.
The food begins to thaw. 
The ambient temperature is too low for this appli-
ance. 
If the ambient temperature is too low, the compres-
sor will run less frequently. This may cause the
freezer to become too warm.
 See the information in the section on “Installation –
Installation location”.
 Increase the ambient temperature.
The compressor runs
continuously.
Not a fault. To save energy, the compressor runs at
a lower speed when less cooling is required. This
increases the compressor run time.
Food has frozen to-
gether or to the wall.
The food packaging was not dry when loaded in the
freezer.
 Use a blunt instrument (such as a spoon handle) to
carefully pry them apart.
An alarm sounds. The appliance doors have been open for longer than
approx. 2minutes.
 Close the appliance doors.
No alarm sounds de-
spite the appliance door
being open.
You have switched off the audible signal.
 Switch the audible signal back on using Settings
mode.
The Sabbath Mode function is switched on: the tem-
perature display is dark and the symbol is shown
on the display.
 You can switch off Sabbath mode at any time (see
“Selecting additional settings – Switching Sabbath
Mode on or off”).
The appliance door
cannot be opened.
The Pull2OpenDoor Assistant is switched on but the
appliance has a handle-free cabinet front.
 For handle-free cabinet fronts, switch on the
Push2OpenDoor Assistant (see “Switching on the
Door Assistant” in “Selecting additional settings”).










