Operation Manual

Problem solving guide
123
Problem Cause and remedy
System lock  appears in
the display when a
function i
s selected.
The system lock  has been acti
vated.
 I
t can be deactivated for a programme to be run
by touching the OK sensor for at least 6 seconds.
 The syst
em lock can be permanently deactivated
(see "Settings – System lock ").
The oven does not heat
up.
Demo mode has been activated.
T
he oven can be operated but does not heat up.
 Deactivat
e demo mode. See "Settings -
Showroom programme".
Power cut - process
cancelled appears in the
d
isplay.
There has been a power cut which has caused a
cu
rrent process to stop.
 Switch the oven off and then back on again.
 S
tart the programme again.
12:00 has appeared in
the display.
The power supply was interrupted for longer than 200
hours.
 Reset the time and dat
e.
Maximum operating duration
reached appears in the
display
.
The oven has been operating for an unusually long
tim
e and this has activated the safety switch-off
function.
 Confirm with OK.
Touch  to delete the message
Prog. finished.
The oven is now ready to use.
 Fault XX appears in
the di
splay.
There is a problem that you cannot resolve.
 C
all the Miele Service Department.
If the door is opened
whilst using Microwave
solo , the oven stops
making a noise.
This is not a fault. If the door is opened while
Micr
owave solo  is being used, the door contact
switch will turn off the microwave and switch the
cooling fan to a lower speed.
A noise can be heard
aft
er a cooking
process.
The fan remains switched on after a cooking
pr
ogramme (see "Settings - Cooling fan run-on").