User Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Overview
- Oven controls
- Features
- Data plate
- Items supplied
- Accessories supplied and available to order
- Shelf runners
- Baking tray, universal tray and rack with non-tip safety notches
- FlexiClip telescopic runners HFC 70-C
- Fitting the FlexiClip telescopic runners
- Removing the FlexiClip telescopic runners
- FlexiClip telescopic runners HFC 7x
- Fitting and removing the FlexiClip telescopic runners
- Perforated gourmet baking tray HBBL 71
- Round baking trays
- Baking stone HBS 60
- Grilling and roasting insert HGBB 71
- HUB Gourmet oven dishes HBD Gourmet oven dish lids
- Catalytic enamelled accessories
- Handle HEG
- Accessories for cleaning and care
- Functions
- Safety features
- PerfectClean treated surfaces
- Cooktop controls
- Before using for the first time
- Overview of functions
- Energy saving tips
- Operation
- Clock/Timer
- Baking
- Roasting
- Grilling
- Other applications
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the telescopic runners)
- Stubborn soiling on the FlexiClip telescopic runners
- Cleaning the catalytic enamelled back panel
- Removing the door
- Dismantling the door
- Fitting the door
- Removing the shelf runners with FlexiClip telescopic runners
- Removing the back panel
- the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
90
Electrical connection
Danger of injury!
Installation, repairs and other work
by unqualified persons could be
dangerous. Miele cannot be held
liable for unauthorised work.
Ensure power is not supplied to the
appliance until after installation or
repair work has been carried out.
All electrical work must be
undertaken by a suitably qualified
and competent person in strict
accordance with current national and
local safety and building code
regulations.
Connection of this appliance must
comply with national and local safety
regulations.
Connection to a switched socket is
recommended as this provides easier
access in the case of a service call.
For extra safety, it is advisable to
protect the appliance with a suitable
residual current device (RCD) with a trip
current of 30 mA.
If the switch is not accessible after
installation an additional means of
disconnection must be provided for all
poles. The means of disconnection
must be incorporated in the fixed wiring
in accordance with the wiring rules.
When switched off there must be an all-
pole contact gap of 3mm in the isolator
switch (including switch, fuses and
relays).
Connection data
AC 230V, 50 Hz
The voltage and rated load are given on
the data plate situated at the front of
the oven frame visible with the oven
door open. Please ensure the
connection data matches the
household supply.
When contacting Miele, please quote
the following:
– Model number
– Serial number
– Connection data (voltage/frequency/
maximum rated load).
If the mains connection cable is
damaged, it must be replaced by a
suitably qualified and competent
person with a specialist connection
cable of type H05 VV-F with a
suitable cross sectional area,
available from Miele, in order to
avoid a hazard.
WARNING - THIS APPLIANCE
MUST BE EARTHED
Wiring diagram
N.B. This appliance is supplied
single phase only in AUS/NZ.
The appliance must only be
connected in accordance with the
options below which include a
neutral conductor (see wiring
diagrams in thick-framed box). The
two connection options below the
thick-framed box are not permitted in
AUS/NZ.