User Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Overview
- Oven controls
- Features
- Data plate
- Items supplied
- Accessories supplied and available to order
- Shelf runners
- Baking tray, universal tray and rack with non-tip safety notches
- FlexiClip telescopic runners HFC 70-C
- Fitting the FlexiClip telescopic runners
- Removing the FlexiClip telescopic runners
- FlexiClip telescopic runners HFC 7x
- Fitting and removing the FlexiClip telescopic runners
- Perforated gourmet baking tray HBBL 71
- Round baking trays
- Baking stone HBS 60
- Grilling and roasting insert HGBB 71
- HUB Gourmet oven dishes HBD Gourmet oven dish lids
- Catalytic enamelled accessories
- Handle HEG
- Accessories for cleaning and care
- Functions
- Safety features
- PerfectClean treated surfaces
- Cooktop controls
- Before using for the first time
- Overview of functions
- Energy saving tips
- Operation
- Clock/Timer
- Baking
- Roasting
- Grilling
- Other applications
- Cleaning and care
- Unsuitable cleaning agents
- Removing normal soiling
- Removing stubborn soiling (excluding the telescopic runners)
- Stubborn soiling on the FlexiClip telescopic runners
- Cleaning the catalytic enamelled back panel
- Removing the door
- Dismantling the door
- Fitting the door
- Removing the shelf runners with FlexiClip telescopic runners
- Removing the back panel
- the top heat/grill element
- Problem solving guide
- Service
- Installation
- Cooking charts
Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
89
Installing the oven
For safety reasons, the oven may
only be used after it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Connect the mains cable from the
oven to the electrical supply.
Do not carry the oven by the door
handle. The door can be damaged.
Use the handle cut-outs on the side
of the housing to lift the appliance.
Remove the door (see “Cleaning and
care - Removing the door”) and the
accessories before installing the
appliance. This makes the oven lighter
when you push it into the housing unit
and you do not run the risk of lifting it
by the door handle by mistake.
Push the oven into the housing unit
and align it.
Open the door, if you have not
removed it.
Use the screws supplied to secure
the oven to the side walls of the
housing unit.
Refit the door, if necessary (see
“Cleaning and care - Refitting the
door”).