Technical data

b
1 hose clip for securing the vent
ducting to the exhaust stub.
c
1 reducing collar
for exhaust ducting ø 125 mm.
d
1 non-return flap
for fitting into the exhaust stub.
e
2 runners
(1 x right, 1x left) to support the ap-
pliance in the wall unit.
f
2 spacer blocks (DA 327 only)
for fitting the appliance in a 70 cm wide
wall unit.
g
2 spacer blocks (DA 329 only)
for fitting the appliance in a 90 cm wide
wall unit.
h
2 cover caps (DA 327/329 only)
(1 x right, 1x left) and two inserts
i
for
covering the support rails when when
fitting in a 70 or 90 cm wide wall unit.
j
2 side spacers
to cover the spaces at the side when fit-
ting in a 60 cm wide wall unit.
k
Facia slot
for inserting the active charcoal filter.
l
Grip
for the front panel.
m
1 spacer strip
to cover the gap between the rear of
the appliance and the wall.
n
1 light cover
with right and left holders
o
.
8 screws 4.0x16 mm
For securing the runners
e
in a 60 cm wide wall unit
or for securing the spacer blocks
f
,
g
in a 70 cm or 90 cm wide wall unit.
6 self-tapping screws
3.5x9.5 mm
2 for securing the light cover
n
,
o
4 for securing the side spacers
j
.
DA 327, 329 only : 8 more screws for
securing the runners
e
to the spacer
blocks
f
,
g
(when fitting in a 70 or 90
cm wide wall unit)
1 strip with 3 adhesive
sections for attaching a
kitchen furniture lightshield to grip
l
.
7 screws 3.0x15 mm
2 for attaching the
grip
l
to the deflector plate; 5 for at-
taching a kitchen furniture lightshield to
grip
l
.
Screwdriver for aligning the furniture
door after the appliance has been built
in.
Installation
23