Operating instructions/Installation instructions

Operation
72
End of program
At the end of a program, the in-opera-
tion indicator light will be flashing slowly
with the door shut. The audible signal
may also be sounding.
The in-operation indicator light will go
out 10minutes after the end of the pro-
gram if the door is closed.
The program has ended when the dis-
play shows the message Finished.
In some programs, if the AutoOpen
function is activated, the door will auto-
matically open slightly (see “AutoOpen”
under “Settings”). This improves the
drying process.
The drying fan may continue to run for
a few minutes at the end of the pro-
gram.
 Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of delicate coun-
tertops when you open the door at
the end of the program if the blower
is no longer running.
If you have deactivated the auto-
matic door-opening function (see
“AutoOpen” under “Settings”), but
would still like to open the door at
the end of the program, then make
sure that you open the door fully.
Energy management
To save energy, the dishwasher will turn
off automatically 10minutes after the
last time a sensor button is pressed or
after the end of a program.
You can turn the dishwasher back on
again with the sensor button.
If the dishwasher has been turned off
for longer than 1minute, you will need
to hold the sensor button for a bit
longer (wipe protection).
The dishwasher will not turn itself off
while a program is running or if there is
a fault.