Operating instructions/Installation instructions

Settings
44
Temperature
You can set whether the temperature
should be displayed in °F/Fahrenheit or
°C/Celsius.
The factory default setting is °C/Cel-
sius.
Display brightness
You can set the display brightness to
one of 7 different levels on the bar
chart.
Volume
A sequence of audible signals will
sound at the end of the program or if
there is a fault, provided that the audi-
ble signals have been activated.
Audible signals in the event of a fault
In the event of a fault, the alarm tone
will sound 4times at intervals with a
short pause between each set of tones.
The alarm tone that sounds when
there is a fault cannot be deacti-
vated.
Audible signals
The audible signals at the end of a pro-
gram will sound 4times at intervals with
a short pause between each signal.
The volume of the audible signals at the
end of the program can be set to one of
7different settings. If no volume is se-
lected, the audible signals are turned
off.
Keypad tone
An audible tone sounds each time a
sensor button outside of the touch dis-
play is pressed.
The volume for the keypad tone can be
set to one of 7different settings. If no
volume is selected, the keypad tone is
turned off (except the On/Offsensor
button).
Welcome melody
If you turn the dishwasher on or off, a
brief melody will sound.
You can turn the melody off.