Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Caring for the environment
- Before using for the first time
- Settings
- Opening the settings menu
- Changing settings
- Closing the settings menu
- Language
- Time
- Water hardness
- AutoDos (AutoDos)
- Rinse aid
- Miele@home
- Remote control
- Remote Update
- SmartStart
- EcoStart
- Temperature
- Display brightness
- Volume
- Memory
- Refill indicators
- AutoOpen
- 2nd interim rinse
- Knock2open
- BrilliantLight
- SaniWash Cycle
- Software version
- Legal Information
- Copyrights and licenses for operator and control software
- Copyrights and licenses for the communication module
- Showroom
- Factory default
- Caring for the environment
- Loading the dishwasher
- Detergents
- Operation
- Options
- Program overview
- Options
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- Optional accessories
- Installation
- Sound emission testing
Frequently Asked Questions
104
Problem Possible cause and solution
The in-operation indica-
tor light is flashing
quickly.
At the end of the pro-
gram, the alarm tone
sounds and the display
shows the following
message:
Fault F 601: A fault has
occured, turn the appliance
off then back on again.
Restart the program. If the
fault occurs agian, contact
Miele Service.
There is a fault in the AutoDos.
Turn the dishwasher off and back on again.
Check whether the PowerDisk holder and the
PowerDisk have been installed correctly (see “Au-
tomatic dispensing/AutoDos” under “Detergent”).
Activate the AutoDos function and restart the pro-
gram.
If the fault message appears again, there is a techni-
cal fault. You can continue to use your dishwasher by
deactivating AutoDos in the Options menu of a pro-
gram and manually dispensing the detergent via the
detergent compartment.
If you wish to use AutoDos again, contact Miele
Customer Service.
The in-operation indica-
tor light is flashing
quickly.
At the end of the pro-
gram, the alarm tone
sounds and the display
shows the following
message:
AutoDos maintenance re-
quired. Please check Auto-
Dos system.
The dishwasher does
not turn off at the end
of the program.
The dishware may not
be clean because an in-
sufficient amount of de-
tergent was dispensed.
The AutoDos function is
automatically deacti-
vated during the pro-
gram sequence.
An empty PowerDisk has been inserted or the Auto-
Dos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDos function was automatically deactivated.
Turn the dishwasher off and back on again.
Multiple messages appear in the display.
Clean the fill channel of the AutoDos (see “Clean-
ing the AutoDos” under “Detergent”).
Clean the lower spray arm (see “Cleaning the
spray arms” under “Cleaning and care”).
Select OK to confirm each message.
Activate the AutoDos function by confirming the
message AutoDos available using OK.
Start the program again.
The program duration will be extended by up to
2.5hours to flush out the AutoDos detergent outlet.