Installation Instructions

Frequently Asked Questions
101
Water intake fault
Problem Possible cause and solution
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Open the water supply The water supply is turned off.
 Open the water supply all the way.
Insufficient water. Open
the water supply all the way.
Refer to Operating Instruc-
tions if necessary
Before remedying the fault:
 Turn off the dishwasher.
Water-intake fault.
 Open the shut-off valve all the way and start the
program again.
 Clean the water-intake filter (see “Cleaning the wa-
ter-intake filter” under “Cleaning and care”).
 The water-connection pressure is lower than
7.25psi (50kPa).
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Water drainage” under “Installa-
tion”).
 Fault F 18: A technical
fault has occcurred. Turn off
the appliance, close the wa-
ter supply and contact Miele
Service.
A technical fault has occurred.
 Turn off the dishwasher.
 Close the shut-off valve.
 Contact Miele Customer Service.
The following fault mes-
sage appears during the
EnergySaver program:
Intake temperature too low
The intake water has not reached the required tem-
perature of 115°F (45°C) (see “Water intake” under
“Installation”).
 Start the program again.
 If the fault message appears again, select a differ-
ent program.