Technical data

Miele
●
9 Independence Way
●
Princeton, NJ 08540
●
609-419-9898
●
800-991-9380
●
Fax [phone]
●
www.dentaldisinfector.com
10
15. Load baskets & inserts into the machine (continued)
D. Adjust the top basket coupling
●
Fully insert top basket, ensuring water coupling
connects with water inlet in the top of the
chamber. Not inserted into machine, this water
coupling must be 4-5 mm higher than the water
connection inlet. If it is not, loosen the plastic
nut, push the adapter 4-5 mm higher than the
water connection inlet, and tighten the plastic nut.
16. Décor panel mounting instructions (optional)
1. Remove the Lower Panel from the G 7881 via the
2 mounting screws (A).
2. Remove the Lower Panel Décor Frame mounting piece via the
6 phillips head screws (B).
3. Slide out the Lower White Décor Panel and replace it
with the laminate sheet.
4. Replace the Lower Panel Décor Frame mounting piece via the
6 phillips head screws (B). Set Lower Panel aside.
5. Remove the bottom piece of the Upper Panel Décor Frame
via the 3 phillips head screws (C).
6. Open the machine door so side screws are accessible (D).
7. Remove both sides of the Upper Panel Décor Frame via the
3 phillips head screws on each side (D).
8. Slide out the Upper White Décor Panel and replace it with the
laminate sheet.
9. Replace the sides of the Upper Panel Décor Frame via the
3 phillips head screws on each side (D).
10. Close the machine door so bottom screw holes are
accessible (C).
11. Replace the bottom piece of the Upper Panel Décor Frame
via the 3 phillips head screws (C).
12. Replace the Lower Panel on the G 7881 via the two
mounting screws (A).
17. Run the program cycle. Program will take ~50 minutes.
If successful, the G 7881 is now ready to operate
D
C
A
A
B
B
D