Technical data

Miele
●
9 Independence Way
●
Princeton, NJ 08540
●
609-419-9898
●
800-991-9380
●
Fax [phone]
●
www.dentaldisinfector.com
8
13. Prime the pumps (continued)
C. Setting & priming the optional DOS G60/1 detergent dispensing system (continued)
●
Turn the program selector to the 1 o'clock position. "do1" appears in the display.
●
Press the "Display" button. The dispensing system will be primed automatically.
"do1" will appear in the display when the priming is finished. Ensure that priming has
occurred by visually inspecting machine chamber for dispensed detergent. If priming
has not occurred, repeat priming step.
●
Press the "Start” button. "SP" will appear in the display.
●
Press the "Start” button again. The setting will now be stored in memory. The
display will go out.
●
After priming, run the "Rinse" program to remove detergent residues from
the wash chamber.
Note: If detergent is allowed to become empty, reference G 7881 Operating Instructions for priming the system.
14. Add the rinse aid
Rinse aid is necessary to ensure water does not cling to and leave marks on items during the drying phase. It also
enables items to dry faster after they have been washed. Rinse aid is poured into the storage reservoir and a
pre-set amount is dispensed automatically. The rinse aid reservoir holds approximately 180 ml.
A. Adding rinse aid
●
The reservoir must be filled with rinse aid
when the"Rinse Aid" indicator illuminates
(as seen in illustration).
There is also a level indicator for the rinse aid
reservoir on the inside of the door.
●
Open the door fully.
●
Unscrew the cap (see illustration).
Inadvertently filling the rinse aid reservoir with detergent (including liquid detergent) will
damage the reservoir. To avoid damage and ensure proper results only use Miele
approved rinse aid.
4
6
6