Technical data

Miele
●
9 Independence Way
●
Princeton, NJ 08540
●
609-419-9898
●
800-991-9380
●
Fax [phone]
●
www.dentaldisinfector.com
6
12. Test the water hardness and activate softener if
necessary (continued)
A. Filling the salt reservoir
●
Remove the bottom basket from the machine.
●
Unscrew the salt reservoir cap.
Before filling the salt reservoir with reactivation salt for
the first time, fill it with approx. ¾ gallon of water.
●
Place the funnel provided in place
(see illustration).
●
Carefully fill the reservoir with salt. Displaced
water will run out as it is being filled.
●
Wipe any residual salt off the screw threads
on the socket.
●
Screw the cap on firmly.
●
Immediately after this step: Run the "Rinse" program
to remove any traces of salt from the cabinet.
Note: There may be a delay before the "Rinse" program
starts due to the reactivation of the water softener.
B. Setting the water softener
●
Turn off the machine with the "On/Off" button.
●
Turn the program selector to the "Stop” position.
●
Press and hold the "Display" and "Start” buttons at the same time.
Simultaneously turn the machine on with the "On/Off" button. The current program
status "P…" will appear in the display and the "Fill/Drain: indicator will illuminate.
●
Press the "Drying" button once. "E01" (programming level 1) will appear in the
display.
●
Turn the program selector one switch position clockwise (1 o'clock position).
The number "19" will appear in the display (this indicates the factory water hardness
setting in gr/gal, equivalent to 340 ppm).
●
Press the "Display" button as many times as necessary or hold it in until the
required value (hardness level in gr/gal) appears in the display. Once the number "60"
has been reached the counter will begin again at "0.
●
Press the “Start” button. “SP” will appear in the display.
●
Press the “Start” button again.
The setting will now be stored in memory. The display will go
out. For future serving, it is useful to make a note of your water
hardness level.
●
Enter your water hardness level here:
__________ gr/gal or __________ ppm
C. Salt Indicator (see illustration)
Reactivation takes place automatically during a program.
The "Recharging" indicator (#1 in illustration) illuminates.
When the salt reservoir is empty, the "Recharge"
indicator (#2 in illustration) illuminates to remind you
to fill the reservoir.
f
6
U
4
4
6
6