Technical data

Miele
●
9 Independence Way
●
Princeton, NJ 08540
●
609-419-9898
●
800-991-9380
●
Fax [phone]
●
www.dentaldisinfector.com
3
7. Either attach proper plug to power cord or hardwire to electrical supply
All electrical work must be performed by licensed professionals and adhere to all applicable Local, State, and Federal Codes.
The machine comes equipped for a connection to 208 V, 60 Hz, 1 phase power supply. It is equipped with a 6ft.
long, 10/3 AWG power cord, without a plug. The installer may either install an electrical plug or hardwire the
machine into an electrical junction box that has been installed on the wall or in a cabinet adjacent to the
machine. It should be connected to the main power supply.
Voltage: 208 V, 1 phase
Possible conversion to three-phase - Contact Miele Technical Support for
additional information. The conversion diagram and the wiring diagram is
secured to the inner side of the service panel.
Frequency: 60 Hz
Rated Load: 60 kW
Circuit Breaker: 2 x 30 A
Black: Connect to L1 (hot)
White: Connect to L2 (hot)
Green: Connect to GND (ground)
WARNING – THIS APPLIANCE MUST BE GROUNDED
8. If applicable, connect the optional DOS G 60/1 power supply and feed hose
(Please refer to DOS G 60/1 Installation Instructions that are shipped with the unit)
The machine must only be operated with the voltage, frequency, and fusing shown on the
data plate located on the rear of the machine and on the plinth (behind the service panel).