Technical data

Miele
●
9 Independence Way
●
Princeton, NJ 08540
●
609-419-9898
●
800-991-9380
●
Fax [phone]
●
www.dentaldisinfector.com
2
1. Examine exterior packaging for damage
●
If damaged, notify carrier and then please call 800-666-0486 for Miele's Returns department.
2. Uncrating instructions
●
Carefully cut the two packing straps.
●
Lift cardboard box off of machine.
●
Properly dispose of all packaging materials. All of the protective packaging material is environmentally
safe and can be recycled.
●
Carefully lift machine from pallet. Do not lift machine by its lid!
3. Remove Operating Instructions manual from the rear of the machine. Save for reference.
Note: You will need the manual and installation diagram for the remaining steps.
4. Open machine door via the emergency release and remove accessory items
(i.e. water inlet filter, drain hose, warranty card, water softener funnel, red empty 5L neutralizer container, steam deflector, etc.)
●
Slowly pull the emergency release cable located at the bottom
of the machine (see illustration).
5. Remove styrofoam blocks from upper basket support and discard
6. Connect drain hose to the rear of the machine using enclosed hose clamp
All plumbing work must be performed by licensed professionals and adhere to all applicable Local, State, and Federal Codes. Note:
plumbing code in certain areas may require the use of the optional Cool Down Kit (Item # Cool Down Kit) to reduce the temperature
of the effluent. Contact Miele Technical Service for ordering and installation information.
●
The drainage system is fitted with a non-return valve which prevents dirty water from flowing back into
the machine via the drain hose.

The drainage system must be able to take a minimum drainage flow of 4 gal/min.

The onsite drain connection point should be located between 1 ft. (0.3 m) and 3 ft. (1 m) above
the lower edge of the machine.

If it is lower that 1 ft. (0.3 m), lay the hose in a curve at a height of at least 1 ft. (0.3 m).
●
The drain hose is approx. 5 ft. (1.4 m) long, is flexible and has an internal diameter of 7/8 in. (22 mm). It
must not be shortened. Hose clamps are supplied for securing it in position.
●
The drainage system must not exceed 12 ft. (4 meters).
The machine should preferably be connected to a separate drainage system such as a standpipe or floor drain.
However, if local code permits the drain hose can be connected to an under-sink ¾" tailpiece.