Operating instructions

Fault Possible cause Remedy
The Add salt indicator
light k flashes.
The salt reservoir was not
replenished, meaning that
the water softener could not
be reactivated.
Fill carefully with salt.
A few minutes after the
start of a programme,
the p / 6 indicator
flashes and the
programme is
cancelled.
Before trying to rectify the
problem, you must:
–
Turn the programme
selector to f (the fault
code goes out).
–
Switch the machine off
with the I-0 switch.
Fault code: F..E:
There is a water inlet fault.
–
Open the stopcock.
– Clean the water inlet
filter, see "Other
problems".
– The water pressure at
the intake is too low. Ask
a plumber for advice.
Then:
– Switch the machine on.
– Start the programme
again.
Problem solving guide
52