Technical data

Buzzer
A buzzer can be programmed for the following functions:
– End of program, constant tone,
– Fault, tone in 1 second rhythm,
– Signal to take a sample, 3 x short with 2 seconds break
The sample extraction must be programmed by the Miele Technical Service Dept.
The displayed numbers conform with the following settings.
20 Buzzer turned off
21 End of program (factory setting)
22 Fault message
23 End of program + fault message
Step Display / Result
^ Press "Drying" until E04 appears in the display.
E04
^ Turn the program selector to "Wash".
21
^ Press and hold "Display" until the desired value
appears in the display.
26
Value set:
The buzzer sounds during the specified setting for 30 seconds.
To turn it off prematurely:
–
Turn the program selector to f.
–
Press the "Display" button.
–
Cut the power, e.g. open the door.
Programming functions
41