Technical data

Loading the machine
–
Load the items to be washed so that
water can access all surfaces.
–
Do not place items inside other
pieces.
–
Water must flow through hollow
instruments.
–
Prior to loading the machine or
connecting to the machine ensure
that vessels with long, narrow
cavities they can be completely
flushed.
– Hollow vessels should be inverted
and placed in the correct inserts so
that water can flow in and out
unrestricted.
– Deep based items should be placed
at an angle to allow water to run off
easily.
– To ensure good water coverage, tall,
narrow and hollow items should be
placed in the center of the baskets
rather than in the corners. Do not
obscure them with larger items
below.
–
Secure light loads with netting and
place small items in a mesh
tray/basket so that they do not
obstruct the spray arms.
–
Mobile units and baskets with an
adapter must engage correctly.
–
The spray arms must not be blocked
by tall items or items which hang in
their path.
–
Use only instruments made from
high-grade stainless steel to avoid
corrosion.
–
Nickel plated instruments and
colored aluminum instruments are
not suitable for machine treatment.
–
Plastic items must be thermally stable.
– Do not wash disposable instruments
in this machine.
– If discoloration or corrosion stains show
over time on the instruments please
contact the Technical Service Dept.
– To avoid injury due to sharp items, it
is recommended to load the machine
starting at the rear and unload in the
reverse order.
Loading the machine
25