Technical data

Electric door lock
The machine is equipped with an
electric door lock.
The door can only be opened if:
^
the machine is connected to the
electrical supply,
^
the ON/OFF button is pressed.
To open the door
^
Press the "Door" button, hold the door
grip and open the door.
,
Do not touch the heating
elements directly after the end of a
program, you could burn yourself.
They remain hot for some time after
the end of the program.
The door cannot be opened after the
start of the program and remains
locked until the program end.
Exception: During the programs "Rinse"
and "Drain" the door can be opened.
The Technical Service Dept. can
program the door to be opened during
the program cycle "Drying".
To close the door
^
Lift the door upwards and push until
it clicks shut. Do not press the "Door"
button while shutting the door.
Opening the door during a
power failure
The emergency release should only
be used when the door cannot be
opened normally, e.g. in the case of
a power failure. Caution during
"Disinfection" programs - see
"IMPORTANT SAFETY
INSTRUCTIONS"!
Use caution when bypassing the
door lock, danger or burns or
scalding!
^ Turn the program selector to f.
^ Turn the machine off with the "On/Off"
button.
^
Reach behind the service panel from
below and pull the ring of the
emergency release downwards.
Opening and closing the door
13