Technical data

A fault message appears in the display
Message Possible cause Remedy A
p
Water intake fault
Open the stopcock
and
check the inlet hose.
The water inlet is
blocked or restricted.
Check whether
–
the stopcock is opened
enough.
–
the inlet hose is kinked.
The water pressure is
too low.
–
Select Low water
pressure in the
Settings/Supervisor level
menu.
,
Technical fault
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
,
Fault
Disinfection
temperature
not reached
During the disinfection
programme the water
temperature was not
reached.
The machine has not
carried out the disinfection
cycle correctly.
Start the programme again.
q
Drain fault
Clean the drainage
system.
The water outlet is
blocked or restricted.
LP version: Clean the
drainage system.
AV version: Call Service.
O
Fill the container
or
One of the external
detergent containers is
empty.
See "Detergent - Empty
sensor".
Fault
Container empty
A To switch off the fault message, press the multi function selector.
Problem solving guide
39