Operating and Installation instructions

Adjusting the interior fittings
88
Removing the dividing panel
(depending on the model)
 Pull the freezer basket out as far as it
will go.
 To release the brackets, use a suit-
able object to turn the slots in the
pegs to a horizontal position(1.).
 Remove the pegs from the brack-
ets(2.).
 Pull the dividing panel upwards to re-
move it.
 To reinsert the dividing panel, place
the brackets in an upright position,
and position the dividing panel into
the brackets so that you hear it click
into place.
 Insert the pegs into the brackets, and
use a suitable object to turn the slots
in the pegs into a vertical position.
 Push the freezer basket all the way
back in.
Removing the ice container
 Open the appliance door as far as it
will go.
The opening angle of the appliance
door must not be limited to 90° be-
cause otherwise the upper freezer
basket cannot be pulled out as far as
it will go.
 Pull the upper freezer basket out as
far as it will go.
 Tilt the ice container forward and
pull it up and out to remove it.
Ice production does not stop when
the ice container has been removed.
Ice cubes can fall into the freezer
basket underneath.
Only remove the ice container for the
shortest time possible or switch off
the ice maker beforehand (see
“Switching off the ice maker” in
“Making ice cubes”).
 To replace the ice container, pull the
upper freezer basket out again as far
as it will go.