Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation
- Installation location
- Installation notes
- Specifications for the plumbed water connection
- Installation dimensions
- Dimensions of the cabinet front
- Building in the appliance
- Before starting...
- Tools required
- Weight of cabinet front
- Aligning the installation niche
- Checking the installation niche
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the refrigeration appliance
- Securing the appliance in the niche
- Preparing the cabinet fronts
- Securing and aligning the cabinet front
- Mounting the fixing brackets
- Securing the covers
- Mounting the cover in a side-by-side combination
- Securing the toe-kick ventilation grille and toe-kick cover
- Water connection
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using SuperFrost
- Temperature and door alarm
- Adjusting the interior fittings
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Water filter
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Declaration of conformity
- Copyrights and licenses
Adjusting the interior fittings
87
Removing the shelf above the
ice maker
Use both hands to grip the front of
the shelf from below and press it on
both sides until you feel resistance
.
When pulling out and inserting the
shelf, make sure that the side walls
are not damaged.
Carefully pull the shelf out to the
front.
To insert it, slide the shelf slowly onto
the guide on both sides and then
slide it all the way in.
Removing the freezer baskets
Open the appliance door as wide as
possible.
The opening angle of the appliance
door must not be limited to 90° be-
cause otherwise the freezer baskets
cannot be removed.
Pull the freezer basket out as far as it
will go.
Raise the snap fastening on both
sides, unclip, and carefully lift the
basket out.
To replace it, pull the telescopic run-
ners out as far as they will go.
Place the freezer basket back in
again.
Slide the basket all the way back in
again until it engages in the snap fas-
tening.