Fitting Instructions

en - Installation
7
Schematic diagram showing the DOS module
Installing the DOS module
The DOS module is supplied with two screws (4.2 x 25 mm) and two
plugs (6 mm) for installation.
 Select a suitably accessible position, e.g. on an adjacent wall or in
a unit for installing the DOS module.
Suspended
installation:
 Using the drawing as a guide fit the screws the correct distance
apart (80.0 mm) and suspend the DOS module from these.
Flat
installation:
Two slots, 76.0 mm apart are provided at the bottom of the DOS
module for fixing the DOS module to a thin carrier or plate. 3.9 mm
diameter screws (not supplied) are required for securing the DOS
module.
 Drill two holes through the plate and screw the DOS module firmly
in place from underneath.