Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Overview
- Control panel
- Description of functions
- Before using for the first time
- Modes / Programs / Menus
- Operation: Steam cooking
- Operation: Combination cooking mode
- Operation: Functions without steam
- Quick guide
- Interrupting operation
- Additional functions
- Setting additional durations
- Turning off automatically
- Switching on and off automatically
- Sequence of an automatic cooking process
- Rapid PreHeat
- Switching off Rapid PreHeat
- Changing the operating mode
- Changing settings during a cooking process
- Changing the temperature
- Changing the core temperature
- Changing the broil level
- Changing the cooking duration
- Deleting a cooking duration
- Deleting a finish time
- Canceling cooking
- MasterChef
- Favorites
- Timer
- General notes
- Steam cooking
- Sous-vide (vacuum) cooking
- Special modes
- Roast probe
- Roast
- Bake
- Broil
- Settings
- Cleaning and care
- Frequently asked questions
- Optional accessories
- IMPORTANT SAFETY INSTRUCTIONS - INSTALLATION
- Detailed dimensions of oven front
- Installation dimensions
- Installation
- Electrical connection
- Caring for the environment
- Technical service, data plate, warranty
- MieleCare
Frequently asked questions
152
Problem Possible cause and solution
Cakes and pastry are
not cooked properly af-
ter following the dura-
tions given in the
recipe.
The set temperature is not consistent with the one
given in the recipe.
Change the temperature.
The grease filter is inserted in the back panel. Baking
takes longer with this filter is place.
Increase the baking duration.
The recipe has been altered. For example, adding
more liquid or eggs can increase the duration re-
quired.
Adapt the temperature or baking duration accord-
ingly.
Cakes or pastry are un-
evenly browned.
The temperature was set too high.
The grease filter has not been taken out of the back
wall.
More than two shelf levels were used for baking.
Bake on a maximum of two levels.
F 10 The suction hose in the water container is
– is not inserted correctly.
– is not positioned vertically.
Connect it properly and make sure it is vertical:
F11
F20
The drain hoses are blocked.
Descale the steam oven (see "Cleaning and care -
Descaling").
If the fault message appears again, switch the ap-
pliance off and contact Miele Service.
F 44 Communication fault
Turn the steam oven off and then back on again
after a few minutes.
If the same message appears again, contact Miele
Service.