Operating and Installation Instructions

Cleaning and care
27
Removing the panels and grease
filters
The grease filters and panels can fall
out
when you are handling them.
This can result in damage.
Make sure you hold the filters and
panels
securely at all times when
handling them.
 DA 6596 D: Pull the front edge of the
panels down out of the lock, lower
them slightly, unhook them at the
back, and take them out.
 DA 6526 D: Pull the outer edge of the
panels down out of the lock, lower
them slightly, unhook them in the
middle, and tak
e them out.
 To remove a grease filter, release the
lo
cking clip. Then, open the filter to a
45° angle, unhook it, and remove it
from the hood.
Cleaning the panels by hand
 Follow the instructions under
"Housing."
Cleaning the grease filters by hand
 Clean the filters with a soft nylon
brush in a mil
d solution of hot water
and dish soap. Do not use undiluted
dish soap.
Unsuitable cleaning agents
Unsuitable cleaners can cause damage
to the filt
er surfaces if used regularly.
Do not use any of the following:
– Lime removers
– Abrasive powders or abrasive liquids
– Aggressive all-purpose cleaners and
degrease
r sprays
– Oven sprays