Technical data

Installing the Con|ctivity 2.0
stick
In order to be able to utilise the
Con|ctivity 2.0 function, the cooktop
must be fitted with the Con|ctivity 2.0
stick. This is supplied with the
rangehood.
^
Please refer to the Installation
instructions for the Con@ctivity 2.0
stick.
In order to be able to utilise the
Con|ctivity 2.0 function, radio contact
must be activated between the cooktop
and the rangehood.
For the Con|ctivity 2.0 function to
work, both appliances must be installed
and functional.
Activation only needs to occur once.
If the appliances are disconnected from
the electricity supply (e.g. due to a
power cut), activation will be retained.
Important! To establish radio contact,
the rangehood and cooktop must be
activated at the same time. First start
activation on the rangehood, and
then on the cooktop.
Activating Con|ctivity 2.0 on
the rangehood
^ Switch off the fan, the cooktop
lighting and the cooktop.
^ Touch the run-on sensor ¢ for
approx. 10 seconds until the 1 sensor
lights up.
^
Touch in turn
–
the 1 sensor,
–
then the IS sensor,
–
and finally the cooktop lighting touch
control I.
If Con|ctivity 2.0 is not activated, the 2
and 3 sensors will flash simultaneously.
Activating Con|ctivity 2.0
40