Operating and installation instructions Cooker hood DA 5390 W, DA 5320 W To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. en - GB, AU, NZ M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Mode of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Miele|home . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children.
Warning and Safety instructions Safety with children This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, installation, use and maintenance of the appliance.
Warning and Safety instructions ~ Before connecting the appliance to the mains supply, make sure that the voltage and frequency details given on the data plate correspond with the on-site electricity supply (see "After Sales Service"). If they do not correspond the appliance could suffer damage. Consult a qualified electrician if in any doubt.
Warning and Safety instructions ~ Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead. These do not guarantee the required safety of the appliance (e.g. danger of overheating). Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes ~ This appliance may only be used in mobile installations such as ships, caravans, aircraft etc.
Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room. One of the following technical measures may be necessary to ensure safe operation.
Warning and Safety instructions Correct use ~ Never use an open flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over an open flame under the cooker hood. When switched on, the cooker hood could draw flames into the filter. Fat particles drawn into the cooker hood present a fire hazard. ~ Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation.
Warning and Safety instructions ~ Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. ~ All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. ~ The appliance must not be connected to a chimney or vent flue which is in use. Neither should it be connected to ducting which ventilates rooms with fireplaces.
Guide to the appliance 10
Guide to the appliance a Telescopic extension piece h Touch control for the hob lighting b Tower This control switches the lighting on and off, and is also a dimmer switch. c Canopy d Grease filters e Decor panels Miele DDW 53x0 (optional accessory) 3 panels are required for the DA 5390 W, and 4 panels for the DA 5320 W. f Control panel g Hob lighting i On/Off touch control for the fan j Controls to select fan power level k Touch control for the run-on option To activate the run-on option.
Mode of operation The cooker hood works with . . . air extraction: The air is drawn in and cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap which is closed when the cooker hood is switched off. No exchange of room and outside air can take place. When the cooker hood is switched on, the non-return flap opens for the cooking vapours to be blown directly outside.
Miele|home + dai2385 Con|ctivity + This cooker hood is communication enabled. Communication module XKM 2000 DA a, available as an optional extra, enables the operation of the cooker hood to be automatically controlled by the operating status of a Miele electric hob with onset controls. For communication to take place, the hob must be fitted with communication module XKM 2000 KM b. – When the hob is switched on the cooker hood lights and the fan also comes on.
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off control. The fan runs at power level "II". The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the DSM 400 control module, then the fan cannot be switched on if the window is shut. The indicator lamp will flash.
Operation Run-on option The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated. ^ Press the + control to activate the automatic switch-off. The indicator lamps for fan power levels I and IV will now light up constantly. Press the – control to deactivate the automatic switch-off function. It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering odours in the air.
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on and off independently of the fan. Should the cooker hood be left on, the fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the hob lighting control to switch on the hob lighting. The indicator lamp will come on. The lighting will switch on at maximum brightness. To dim the hob lighting The brightness of the lighting can be adjusted.
Operation Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. The operating hours counter tells you when the grease filters need to be cleaned. Resetting the operating hours counter for the grease filters After 30 hours of operation (or another time if the operating hours counter has been altered), the grease filter indicator lamp will light up. The grease filters must then be cleaned.
Operation Altering the filter operating hours counter The filter operating hours counter is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours – Select a short time if you roast or fry a lot.
Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug removed, or – the fuse from the fused spur connection unit is withdrawn, or – the mains fuse is withdrawn, or – the screw-out fuse is removed (in countries where this is applicable).
Cleaning and care Important for appliances with lacquered housing (special order finish) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colours and if there is halogen lighting in the kitchen. An oversaturated filter is a fire hazard. If decor panels are fitted as an optional extra, these need to be removed first.
Cleaning and care Cleaning the grease filters by hand ^ Clean the filters with a soft nylon brush in a mild solution of hot water and a small amount of washing-up liquid. Do not use undiluted washing up liquid. When removing the filters for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. When putting the grease filters back in position, ensure that the locking clips are facing down towards the hob.
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that– – it is switched off at the isolator, or – it is switched off at the wall socket and the plug is withdrawn, or – the fuse from the fused spur connection unit is withdrawn, or – the mains fuse is disconnected, or – the screw-out fuse is removed (in countries where this is applicable). ,Exercise caution when changing halogen lamps.
After Sales Service In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed. For G.B.
Appliance dimensions DA 5390 W DA 5320 W 24
Appliance dimensions The shaded areas 1) and 2) represent the wall or ceiling area for the vent cut-out, for feeding the connection cable through to an external fan and for fitting the connection socket.
Installation Assembly parts 26
Installation a 3 protective sheets for use when fitting the tower. b 2 hose clips for securing the exhaust ducting. c Telescopic wall bracket for securing the cooker hood to the wall. 2 screws 3.9 x 7.5 mm for securing the tower. 1 hexagonal (Allen) key for adjusting the height of the appliance. Installation instructions 1 lever for dismantling the tower. 6 screws 5 x 40 mm and 6 x S 8 plugs for securing the bracket to the wall. The screws and plugs are designed for use in solid walls only.
Installation Dismantling Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at the beginning of this book. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on air from the same room, as this could result in the build-up of toxic fumes.
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
Operation with Control module DSM 400 The Miele DSM 400 Control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance.
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. The control module is supplied with its own detailed operating and installation instructions.
Connection for air extraction ,Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from the building inspector where necessary.
Connection for air extraction For exhaust ducting with a diameter of 200 mm, the following accessories are required: – Exhaust hose DAS 200 – Exhaust grille DFG 200, for mounting on the external wall. *Lead flashing – Roof ducting DDF 200, for mounting on a sloping tiled roof. – Reducing collar for the exhaust stub if using exhaust ducting with a 150 mm diameter.
Technical data Total connected load - DA 5390 W . . . . . . . . . . . . . . . . 580 W - DA 5320 W . . . . . . . . . . . . . . . . 600 W Fan. . . . . . . . . . . . . . . . . . . . . . . . 500 W Hob lighting - DA 5390 W . . . . . . . . . . . . . . 4 x 20 W - DA 5320 W . . . . . . . . . . . . . . 5 x 20 W Voltage . . . . . . . . . . . . . . . . . . . . 230 V Frequency . . . . . . . . . . . . . . . . . . 50 Hz Fuse rating GB . . . . . . . . . . . . . . . . 13 A AUS, NZ: Plug rating . . . . . . . . . . . . . . .
Alteration rights reserved / 4209 M.-Nr.
