Operating and installation instructions Cooker hood DA 489-4 DA 489-4 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Modes of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Operation . . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children.
Warning and Safety instructions Technical safety This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, installation, use and maintenance of the appliance.
Warning and Safety instructions The appliance is only completely isolated from the electricity supply when: – it is switched off at the isolator, or it is switched off at the wall socket and the plug withdrawn, or – the fuse from the fused spur connection unit is withdrawn, or – the mains fuse is withdrawn, or the screw-out fuse is removed (in countries where this is applicable). Do not connect the appliance to the mains electricity supply by an extension lead.
Warning and Safety instructions Do not use a steam-cleaner to clean this appliance. Pressurised steam could reach the electrical components and cause a short circuit. Safety with children The appliance is only intended for use by adults who have read these instructions. It is not a toy! To avoid the risk of injury, keep children well away, and do not allow them to play with it or use the controls. They will not understand the potential dangers posed by it.
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions One of the following technical measures may be necessary to ensure safe operation. – If the only way of ensuring adequate ventilation is via an open window, a window contact switch should be fitted to ensure that the cooker hood can only operate when the window is opened sufficiently. A window contact switch kit is available from good builders' merchants. Take care when ventilating the room through an open window that ventilation is not impaired by a closed blind or curtain.
Modes of operation The cooker hood works with . . . air recirculation: . . . air extraction: (requires a conversion kit and charcoal filter: see "Technical Data") The air is drawn in through the vapour plates, cleaned by the grease filter and directed outside. If the on-site ventilation system does not have a non-return flap, then the non-return flap supplied with the appliance must be fitted in the exhaust socket in the motor unit.
Guide to the appliance 10
Guide to the appliance a Telescopic extension piece n Touch control for the grease filter b Recirculation grille The indicator lamp for the grease filter touch control lights up when the vapour plates and grease filter need to be cleaned.
Operation To switch the fan on ^ Press the On/Off control. The fan runs at power level "II". The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele DSM 400 control module, then the fan cannot be switched on if the window is shut. The indicator lamp will flash. To select a power level ^ Use the – / + controls to select the power level required.
Operation The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated. ^ Press the + control to activate automatic switch-off. The indicator lamps for fan power levels I and IV will now light up constantly. Press the – control to deactivate the automatic switch-off function. ^ Press the run-on option control to confirm your selection.
Operation To switch the hob lighting on To switch the hob lighting off The hob lighting can be switched on and off independently of the fan. ^ Press the hob lighting control briefly to switch the lighting off. The indicator lamp will go out. Safety cut-out ^ Briefly press the lighting control to switch on the hob lighting. Should the cooker hood be left on, the fan will switch off automatically after 10 hours. The lighting will remain on. The indicator lamp will come on.
Operation Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. The operating hours counter tells you when the grease filter or charcoal filter need to be cleaned or replaced. Resetting the grease filter operating hours counter After 30 hours of operation (or another time if the operating hours counter has been altered), the grease filter indicator lamp will light up. The vapour plates and the grease filter must then be cleaned.
Operation Altering the grease filter operating hours counter The grease filter operating hours counter is set at the factory for 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours. – Select a short time if you roast or fry a lot. – If you use very little fat for cooking, select a longer time.
Operation To activate and alter the charcoal filter operating hours counter ^ Use the – /+ controls to select the desired time. (in recirculation mode) The charcoal filter is needed for recirculation mode. On delivery, the operating hours counter for the charcoal filter is deactivated, ^ Confirm the selection by pressing the charcoal filter control. For recirculation mode, the operating hours counter needs to be set to suit the type of cooking you do: All the indicator lamps will go out.
Operation Resetting the charcoal filter operating hours counter Reading the charcoal filter operating hours counter The indicator lamp for the charcoal filter control will light up after the cooker hood has operated for the number of hours set. The charcoal filter must then be replaced with a new one (see "Cleaning and care"). To check the percentage of time set already used: Afterwards, the charcoal filter operating hours counter must be reset. ^ Press the On/Off control to switch the fan on.
Cleaning and care Before carrying out any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator or at the wall socket and the plug removed, or – the fuse is withdrawn from the fused spur connection unit, or – the mains fuse is withdrawn, or – the screw-out fuse is removed (in countries where this is applicable). – abrasive cleaning agents, e.g.
Cleaning and care Vapour plates and grease filter The vapour plates and the re-useable metal grease filter remove solid particles from the kitchen vapours (grease, dust, etc) preventing soiling of the cooker hood. The vapour plates and grease filter should be cleaned regularly (at least every 3-4 weeks) to avoid a build-up of fat. An oversaturated filter is a fire hazard. ^ First, remove the vapour plate in the middle.
Cleaning and care Cleaning the grease filter by hand ^ Clean the filter with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing up liquid. Do not use: – cleaning agents containing descaling agents, ^ To remove the side vapour plates, hold on the side, pull out of the holder at the bottom (1), then slide towards the middle and pull downwards (2). ^ See the notes under "Housing" for how to clean the vapour plates.
Cleaning and care When removing the filter for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. ^ Replace the grease filter. ^ Replace the vapour plates. First, slide the side vapour plates in at the top, push sideways into place, and click into place at the bottom. ^ Fit the middle vapour plate into the slots at the top (1), then click into place at the bottom (2).
Cleaning and care Glass surfaces ^ Glass surfaces can be cleaned using a proprietary non-abrasive cleaning agent designed specifically for use on glass. – Avoid oven sprays. Fitting and replacing the charcoal filter If the cooker hood is connected for recirculation, a charcoal filter must be inserted in addition to the grease filter. This is designed to absorb cooking odours. It is fitted in the canopy above the grease filter.
Cleaning and care When fitting for the first time: ^ Activate the operating hours counter (see "Operation"). Always replace the charcoal filter immediately if – the indicator lamp for the charcoal filter lights up, or – if it is no longer effective in absorbing kitchen odours. It should, however, be replaced at least every 6 months. Used charcoal filters can be disposed of with the normal household waste. ^ After fitting the new charcoal filter, press the charcoal filter touch control for approx.
Cleaning and care Changing the halogen lamps Disconnect the cooker hood from the mains supply by: - switching it off at the isolator or at the wall socket and removing the plug, or - withdrawing the fuse from the fused spur connection unit, or - withdrawing the mains fuse, or - removing the screw-out fuse (in countries where this is applicable). Exercise caution when changing halogen lamps. They get very hot during use, and remain hot for some time after being switched off.
Appliance dimensions 1) Extraction 2) Recirculation 3) Ventilation grille positioned at the top for recirculation 4) and 5): (5 is not required for recirculation mode cooker hoods) The shaded area represents the wall or ceiling area for the vent cut-out, for fitting the connection socket and on ...EXT models for feeding the connection cable through to the external motor. For recirculation mode, only a connection socket needs to be fitted.
Appliance dimensions Safety distance between hob and cooker hood (S) The safety distance between the top of a cooker or hob and the bottom of the cooker hood glass canopy must measure at least 350 mm, unless a greater distance is specified by the manufacturer of your cooking appliance. See "Warning and Safety instructions". – Account should also be taken of the height of the person who will be using the hood most often.
Installation Assembly parts 28
Installation a 3 protective sheets for use when fitting the tower. b 2 hose clips for securing the exhaust ducting. c 1 reducing collar for exhaust ducting C 125 mm (not on EXT models). d 1 non-return flap for fitting into the exhaust connection on the motor unit (only for air extraction mode, not on EXT models). 8 large headed screws 5 x 40 mm and 8 x S 8 plugs for securing the retaining plates and the appliance unit. The screws and plugs are designed for use in solid walls.
Installation Dismantling Before installation, it is important to read the information given on the following pages as well as the Appliance dimensions and the Warning and Safety instructions at the beginning of this book. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on air from the same room, as this could result in the build-up of toxic fumes.
Connection for air extraction Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local building regulations. Seek approval from the building inspector where necessary. – Where ducting is horizontal, it must be laid to slope away at at least 1 cm per metre.
Connection for air extraction Important: Silencer If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. (optional accessory for ...EXT models only) Condensate trap (optional accessory) To achieve even further reductions in noise levels, ...
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
Operation with DSM 400 control module The Miele DSM 400 control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance.
Operation with DSM 400 control module Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. A fixing bracket is required for fitting the control module. This is available as an optional accessory (M.-Nr. 8363350). The control module is supplied with its own detailed operating and installation instructions.
After sales service In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer or – the Miele Service Department (see back cover for contact details). When contacting the Service Department, please quote the model and serial number of your appliance These are shown on the data plate which is visible when the vapour plates are removed. Please note that telephone calls may be monitored and recorded for training purposes.
Technical data Total connected load* . . . . . . . . . 280 W – Fan motor* . . . . . . . . . . . . . . . . 200 W – Hob lighting . . . . . . . . . . . . . 4 x 20 W Voltage. . . . . . . . . . . . . . . . . . AC 230 V Frequency . . . . . . . . . . . . . . . . . . 50 Hz Fuse rating . . . . . . . . . . . . . . . . . . . 13 A Weight DA 489-4 . . . . . . . . . . . . . . . . . . 34.5 kg DA 489-4 EXT . . . . . . . . . . . . . . 31.
Alteration rights reserved / 3906 M.-Nr.