Technical data
Table Of Contents
- Contents
- Caring for the environment 3
- Warning and Safety instructions 4
- Guide to the appliance 10
- Modes of operation 12
- Miele|home 13
- Operation 14
- Cleaning and care 21
- Appliance dimensions 28
- Installation 30
- Connection for air extraction 33
- Electrical connection 36
- Operation with DSM 400 control module 37
- After sales service 38
- Technical data 39

^
To remove the side vapour plates,
hold on the side, pull out of the
holder at the bottom (1), then slide
towards the middle and pull
downwards (2).
^ See the notes under "Housing" for
how to clean the vapour plates.
^
Pull the grease filter by the hand-hold
forwards and out.
Cleaning the grease filter by hand
^
Clean the filter with a soft nylon brush
in a mild solution of hot water and a
small amount of washing-up liquid.
Do not use undiluted washing-up
liquid.
Do not use:
–
cleaning agents containing
descaling agents,
–
powder cleaners, cream cleaners or
abrasive all-purpose cleaning
agents,
– oven sprays.
Cleaning the grease filter in the
dishwasher
^ Place the filters as upright as
possible in the lower basket, with the
short sides upright. Make sure that
the spray arm can move freely.
^ Do not wash at more than 65° C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^
Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^
After cleaning, leave the filter to dry
for a while on an absorbent surface
before putting it back in place.
Cleaning and care
23










