Technical data

a Telescopic extension piece
b Recirculation grille
(only for recirculation mode)
c Tower
d Canopy
e Control panel
f Hob lighting
g Grease filter
h Charcoal filter
(special accessory for recirculation
mode)
i Vapour plates
j Touch control for hob lighting
This control switches the lighting on
and off, and is also a dimmer switch.
k On/Off touch control for the fan
l Touch controls to select fan power
level
m Touch control for the run-on
option
To activate the run-on option. The fan
can be set to continue running, and to
switch off automatically after either 5 or
15 minutes.
n Touch control for the grease filter
The indicator lamp for the grease filter
touch control lights up when the vapour
plates and grease filter need to be
cleaned.
The touch control is used to reset the
operating hours counter every time the
grease filter and vapour plates are
cleaned (see "Cleaning and care").
It can also be used to check and alter
the operating hours counter.
o Touch control for the charcoal
filter
The indicator lamp for the charcoal filter
lights up when the charcoal filter used
in recirculation mode needs to be
replaced. For this to happen, the
operating hours counter needs to be
activated before the appliance is used
for the first time.
The touch control is used to reset the
operating hours counter every time the
charcoal filter is replaced (see
"Cleaning and care").
It can also be used to check and alter
the operating hours counter.
For information about using the
appliance, see "Operation".
Guide to the appliance
11