Operating and installation instructions Cooker hood DA 289-4, DA 289-4 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Modes of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Operation . . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children.
Warning and Safety instructions Technical safety This appliance complies with all relevant legal safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, installation, use and maintenance of the appliance.
Warning and Safety instructions The appliance is only completely isolated from the electricity supply when: hood could draw flames into the filter. Fat particles drawn into the cooker hood present a fire hazard. – it is switched off at the wall socket and the plug withdrawn, When using the cooker hood over a gas hob, ensure that any burners in use are always covered by a pan. The burner should be switched off before taking a pan off the hob, even for brief periods.
Warning and Safety instructions Safety with children Installation The appliance is only intended for use by adults who have read these instructions. The distance betwen the top of the cooker/hob and the bottom of the cooker hood canopy must measure at least 365 mm, unless a greater distance is specified by the manufacturer of the cooker or hob. It is not a toy! To avoid the risk of injury, keep children well away, and do not allow them to play with it or use the controls.
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions One of the following technical measures may be necessary to ensure safe operation. – If the only way of ensuring adequate ventilation is via an open window, a window contact switch should be fitted to ensure that the cooker hood can only operate when the window is opened sufficiently. A window contact switch kit is available from good builders' merchants. Take care when ventilating the room through an open window that ventilation is not impaired by a closed blind or curtain.
Modes of operation The cooker hood works with . . . air extraction: . . . an external fan: ( ...EXT models only) The air is drawn in through the vapour plate, cleaned by the grease filter and directed outside. If the on-site ventilation system does not have a non-return flap, the non-return flap supplied with the appliance must be fitted in the exhaust socket in the motor unit. The ...EXT models are designed to be connected to an external fan located outside the room.
Guide to the appliance 10
Guide to the appliance a Extension piece b Tower c Canopy d Touch controls e Hob lighting f Grease filter g Vapour plate h Touch control for the hob lighting This control switches the lighting on and off, and is also a dimmer switch. i On/Off touch control for the fan j Touch controls to select fan power level k Touch control for the run-on option The fan can be set to continue running and switch off automatically after either 5 or 15 minutes.
Operation To switch the fan on ^ Press the On/Off control. The fan runs at power level "II". The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele DSM 400 control module, then the fan cannot be switched on if the window is shut. The indicator lamp will flash. Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III.
Operation Run-on option The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated. ^ Press the + control to activate automatic switch-off. The indicator lights for fan power levels I and IV will come on. Press the – control to deactivate automatic switch-off. ^ Press the run-on option control to confirm your selection.
Operation To switch the lighting on Safety cut-out The hob lighting can be switched on and off independently of the fan. Should the cooker hood be left on, the fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting. The indicator lamp will come on. The lighting will switch on at maximum brightness. Dimming the lighting The brightness of the lighting can be adjusted.
Operation Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. One or more of the indicator lamps for the – / + controls will flash. The indicator lamp for the grease filter control will come on after 30 hours of operation. The vapour plate and the grease filter must then be cleaned. Afterwards, the filter operating hours counter must be reset. ^ To do this, press and hold the grease filter control for about 3 seconds.
Operation Filter operating hours counter The operating hours counter for the grease filters is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose from 20, 30, 40 or 50 hours. – Select a short time if you roast or fry a lot.
Cleaning and care Do not use: Before carrying out any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the wall socket and the plug withdrawn, or – the fuse is withdrawn from the fused spur connection unit, or – the mains fuse is withdrawn, or – the screw-out fuse is removed (in countries where this is applicable).
Cleaning and care Controls The controls may suffer discolouration or damage if soiling is left on them for too long. Remove soiling straight away. To avoid damaging the filter or the hob below, make sure you hold the filter securely at all times when handling it. To remove the vapour plate Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls.
Cleaning and care Cleaning the grease filter by hand ^ Clean the filter with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing up liquid. Do not use: – cleaning agents containing descaling agents, – alkaline cleaning agents (with a pH value higher than 7), such as powder cleaners, cream cleaners or abrasive all-purpose cleaning agents, – oven sprays.
Cleaning and care Changing a halogen lamp Disconnect the cooker hood from the mains supply by – switching it off at the wall socket and removing the plug, or – withdrawing the fuse from the fused spur connection unit, or – withdrawing the mains fuse, or – removing the screw-out fuse, (in countries where this is applicable). Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off.
After Sales Service In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer or – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed. Please note that telephone calls may be monitored and recorded for training purposes.
Appliance dimensions 22
Appliance dimensions The shaded areas 1) and 2) represent the wall or ceiling area for the vent cut-out, for fitting the connection socket and, in the case of EXT models, for feeding the connection cable through to an external fan. Connection for air extraction C 150 mm, or C 125 mm with reducing collar.
Installation Assembly parts 24
Installation a 3 protective sheets for use when fitting the tower. b Upper retaining plate for securing the extension piece. c Middle retaining plate for securing the extension piece. 6 screws 3.5 x 9.5 mm for securing the canopy and the filter housing d 2 hose clips for securing the exhaust ducting. e 1 reducing collar for exhaust ducting C 125 mm (not on ...EXT models). f 1 non-return valve for fitting into the exhaust socket on the motor unit (not on ...EXT models).
Installation Dismantling Before installation, it is important to read the information given on the following pages as well as the Appliance dimensions and the Warning and Safety instructions at the beginning of this book. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on air from the same room, as this could result in the build-up of toxic fumes.
Connection for air extraction Important: To avoid the danger of toxic fumes please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from the building inspector where necessary. – Where ducting is horizontal, it must be laid to slope away at at least 1 cm per metre.
Connection for air extraction Important: Silencer If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. Condensate trap (optional accessory) To achieve even further reductions in noise levels, a special silencer can be fitted in the ducting system.
Electrical connection be provided for all poles. All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
Operation with Control module DSM 400 The Miele DSM 400 Control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance.
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. The control module is supplied with its own detailed operating and installation instructions.
Technical data Total connected load* . . . . . . . . . 240 W - Fan motor*. . . . . . . . . . . . . . . . . 200 W - Hob lighting . . . . . . . . . . . . . . 4 x 10 W Halogen lamps Osram type 44888 WFL, 10 W Voltage UK, NZ, ZA . . . . . . . . . . . . . . . AC 230 V AUS . . . . . . . . . . . . . . . . . . . . AC 240 V Frequency . . . . . . . . . . . . . . . . . . 50 Hz Fuse rating (UK) . . . . . . . . . . . . . . . . 3 A AUS, NZ: Plug rating . . . . . . . . . . . . . . . . . . . 10 A Test marks . . . . . . . .
Alteration rights reserved / 1306 M.-Nr.
