Installation Instructions DA 2210 DA 2280 en-CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. ~ This appliance is intended for residential use only. Use the appliance only for its intended purpose. ~ This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage.
IMPORTANT SAFETY INSTRUCTIONS ~ d) Before connecting the appliance to the power supply make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent appliance damage. If in doubt consult a qualified electrician. ~ e) Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and other work by unqualified persons could be dangerous.
IMPORTANT SAFETY INSTRUCTIONS ,WARNING TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A COOKTOP GREASE FIRE, OBSERVE THE FOLLOWING*: ~ Do not allow children to play with or ~ a) SMOTHER FLAMES with a close fitting lid, cookie sheet, or metal tray then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. ~ Never operate gas burners without ~ b) NEVER PICK UP A FLAMING PAN - You may be burned.
IMPORTANT SAFETY INSTRUCTIONS Installation ~ g) Do not install this hood over cooktops that burn solid fuel. ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
Appliance dimensions DA 2280 25
Appliance dimensions DA 2210 26
Appliance dimensions *Cut out dimensions A depth T, min. 1" (25 mm), is necessary in the rear of the cabinet. Distance between cooktop and hood (S) Do not install this exhaust hood over cooktops burning solid fuel.
Installation ^ Please read the "Important Safety Instructions" and Installation instructions before installing this hood. Non-return flap Installation The hood is designed to be installed within cabinetry and kitchen islands. The top half (motor and fan assembly) should be accessible after installation. If the motor and fan assembly are not accessible, assemble the ductwork and the electrical connection before the installation. The hood comes equipped with a non-return flap.
Installation Preparation for air extraction mode ^ See "Air extraction" for further information on installing the exhaust hose. ^ DA 2210: The hood has two vent collars for two 6" (150 mm) diameter exhaust hoses. The supplied Yadapter can be used to feed the exhaust from both connections into an 8" (200 mm) diameter common duct. dai2699 ^ If using a 6" (150 mm) diameter exhaust hose, attach the supplied vent collar to the exhaust hose with a hose clamp.
Installation 14 3 dai2453 Recirculation mode DA 2280 installation needs one installation kit and two active charcoal filters 31 9 DA 2210 installation needs two installation kits and four active charcoal filters 10 A non-return flap is not needed in recirculation mode. 24 ^ Install the installation kit according to the installation situation.
Installation Installing the joystick Joystick extension The joystick can be extended for an easier reach. ^ Screw the spring into the socket and tighten by hand. At the same time hold the socket using a SW 9 wrench, do not rotate. ^ Screw the base onto the spring and tighten by hand. Again, hold the socket with the wrench, do not rotate. ^ Place the bottom section of the joystick onto the base and loosely secure it in place with the included screw and spring washer.
Installation Electrical connection Before connecting the appliance to power read the "Important Safety Instructions". ^ Plug in the power cord. Before using the appliance remove the grease filters and remove the protective foil from the filter frame. Insert the grease filters back into place.
Air extraction ,WARNING Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl spaces or garages. To reduce the risk of fire, only use metal ductwork.
Air extraction Condensate trap optional accessory – If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. Important If the ductwork runs through rooms, ceilings, garages, etc.
Electrical connection ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: All electrical work should be performed by a qualified electrician in strict accordance with national regulations (for USA: ANSI-NFPA 70) and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. Ensure that power to the appliance is off while installation or repair work is performed.
Technical data DA 2280 Maximum load . . . . . . . . . . . . . . . 450 W Fan. . . . . . . . . . . . . . . . . . . . . . . 350 W Light. . . . . . . . . . . . . . . . . . . . 2 x 50 W DA 2210 Maximum load . . . . . . . . . . . . . . . 900 W Fan . . . . . . . . . . . . . . . . . . . 2 X 350 W Light. . . . . . . . . . . . . . . . . . . . 4 x 50 W Voltage . . . . . . . . . . . . . . . . . . . . . 120 V Frequency . . . . . . . . . . . . . . . . . . 60 Hz Circuit rating. . . . . . . . . . . . . . . . . .
Alteration rights reserved / 0910 M.-Nr. 07 773 240 / 01 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.
