Operation Manual

Installation
42
Preparing the worktop
 Create the worktop cut-out. Remem-
ber to maintain the minimum safety
distances (see “Safety distances”).
 Seal any cut surfaces on wooden
worktops with a special varnish, sil-
icone rubber or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be tem-
perature-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
Flush-fit installation
 For wooden worktops, secure the
wooden frames 5.5mm below the
upper edge of the worktop.
For CS 7611, the wooden frame must
be secured 7mm under the upper
edge of the worktop.