Installation and Operation Guide
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Overview
- Before using for the first time
- Suitable cookware
- Tips on saving energy
- Operation
- Safety features
- Cleaning and care
- Problem solving guide
- Optional accessories
- Service
- Installation
- Safety instructions for installation
- Safety distances
- Detailed dimensions
- Surface-mounted
- Installation notes – surface-mounted
- Worktop cut-out – surface-mounted
- Spacer bars – surface-mounted
- Installation dimensions – Surface-mounted
- Installation – surface-mounted
- Flush-fit
- Installation notes – flush-fit
- Worktop cut-out – flush-fit
- Spacer bars – flush-fit
- Installation dimensions – Flush
- Installation – flush-fit
- Gas connection
- Electrical connection
- Burner ratings
- Conversion to another type of gas
Installation
*INSTALLATION*
36
Safety instructions for installation
Damage from falling objects.
Take care not to damage the SmartLine appliance when fitting wall units or a
rangehood above it.
Fit the wall units and the rangehood before the SmartLine appliance.
The room in which the SmartLine appliance is installed must
conform to all relevant local and national building regulations and
safety regulations.
In Australia and New Zealand, gas installations must be in
accordance with AS/NZS 5601.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100°C heat-resistant adhesive which will
not dissolve or distort. Any splashbacks must be of heat-resistant
material.
An electric fryer must not be installed directly next to a gas
cooktop as the gas flames could ignite the fat in the fryer. It is
essential to maintain a distance of at least 288mm between these
two appliances.
The SmartLine appliance must not be installed over a fridge,
fridge-freezer, freezer, dishwasher, washing machine, washer-dryer
or tumble dryer.
When installing the SmartLine appliance, make sure that the gas
pipe and mains connection cable cannot come into contact with hot
appliance parts.
The mains connection cable and any flexible gas connection pipes
must be installed in such a way so that they do not come into
contact with any moving kitchen parts (e.g. a drawer) after the
SmartLine appliance has been installed, and that they cannot be
subjected to any mechanical action which could cause damage.
Carefully observe the safety clearances listed on the following
pages.