Operating and Installation instructions

Lava rocks
Clean the lava rocks on a regular basis.
To do so, put the rocks in a container
with mild solution of warm water and
liquid dish soap. Let them soak briefly,
stirring occasionally. Drain water and
rinse rocks. Repeat this process 2 to 3
times with fresh water. Lay the rocks on
a large kitchen towel to dry.
Cleaning the lava rocks removes the
used layer to expose a fresh
surface. The rate at which the lava
rocks become worn depends on the
frequency and duration of use.
If the amount of lava rocks in the
lava rock container has deceased
by half, the container must be
refilled.
Water trough
^
Let the water cool to a safe
temperature to prevent burns.
^
Place a container (large enough to
hold all water in the trough) under the
drain valve.
^
Slowly open the drain valve by
turning it counterclockwise, a.
^ Once the water has drained, close
the drain valve by turning it
clockwise, b until the water flow
stops.
^ Fill the water trough with a mild
solution of liquid dish soap and warm
water, and rinse it out thoroughly.
Use a bottle brush to clean the drain
^
Allow the solution to drain.
^
Rinse with warm water and dry.
Do not use stainless steel
conditioner on the water trough.
Make sure that the underside of the
appliance is always accessible for
draining away the water. Remember
to let the water cool before draining
to prevent burns.
Cleaning and care
15