Installation

Installing the appliance /
appliances
^
Feed the power cord down through
the cut-out.
^
Place the front edge of the appliance
into the cut-out.
^
With a hand on each side of the
appliance press down evenly on the
edges until it clicks into position.
When doing so make sure that the
appliance seal sits tightly on the
countertop to ensure it is sealed
correctly. This is important to ensure
an effective seal. Do not permanently
seal into the countertop.
When installing more than one
appliance, a sealing strip must be
inserted into the support bar.
^ Push the installed appliance to the
side until the slots in the support bar
are visible.
^
Insert the sealing strip d into the
slots in the support bar b.
^
Place the front edge of the next
appliance into the cut-out.
^
Connect the appliance / appliances
to the main power supply (see
"Electrical connection").
^
Turn the appliance / appliances on
and check the function.
The appliance may be lifted out
using a special tool.
The appliance can also be pushed
up and out from underneath.
Note: push the rear out first.
Installation
36