Operating and Installation Instructions

Burner
Do not clean any parts of the burner
in a dishwasher.
The burner can be dismantled and
cleaned when cool.
^
Remove the burner parts and wash
them in a solution of warm water and
liquid dish soap. Dry them
thoroughly. Make sure that the flame
holes are clean and completely dry.
^
Wipe the burner base clean with a
damp cloth and then dry.
Gently wipe the ignitor and ignition
safety control with a slightly damp
cloth, and then wipe dry.
Do not let the ignitor get wet. If it
gets wet it will not spark.
^ After cleaning dry all surfaces with a
clean cloth.
Reassembling the burner
^ Place cover plate c over burner
base d so that the ignitor and the
ignition safety control extend through
their respective holes in the cover
plate. The cover plate must sit evenly
over the burner base.
Do not use a warped cover plate.
^
Place the burner base in position
above the cover plate making sure
that pins e slot into their respective
holes in the burner head b.
^
Place burner cap a in position.
Be careful not to mix up the parts.
Cleaning and care
17