Operating and Installation Guide
Table Of Contents
- Contents
- Guide to the combiset 4
- IMPORTANT SAFETY INSTRUCTIONS 6
- Before using the combiset 11
- Use 12
- Cookware 15
- Safety features 16
- Cleaning and care 17
- Frequently asked questions 19
- Technical Service 22
- IMPORTANT SAFETY INSTRUCTIONS 25
- Installation 28
- Electrical connection 38
- Gas connection 39
- Converting to another type of gas 42
- Help protect our environment 43
The burner does not ignite after several attempts.
Possible fault Solution
Disconnect the appliance from the electrical supply for a few seconds. If the
problem persists, check if:
– The burner is assembled incorrectly.
– The gas valve is closed.
– The burner is wet and soiled.
– The flame slits are dry and
unblocked
– Reassemble the burner as shown in
"Cleaning and Care - Burners".
– Open the gas valve.
– Clean the burners. See "Cleaning
and Care".
– Dry the igniters.
The flame goes out after being lit.
Possible fault Solution
The flames are not touching the ignition safety control. Check if:
– The burner is assembled incorrectly.
– There is no soiling on the ignition
safety control.
– Reassemble the burner as shown in
"Cleaning and Care - Burners".
– See "Cleaning and Care".
The flame appears different than usual.
Possible fault Solution
The burner is assembled incorrectly. Reassemble the burner as shown in
"Cleaning and Care - Burners".
The flame goes out during operation.
Possible fault Solution
The burner is assembled incorrectly. Reassemble the burner as shown in
"Cleaning and Care - Burners".
Frequently asked questions
20