Operating and Installation Guide
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 4
- Guide to the combiset 9
- Before using the combiset 11
- Use 12
- Cookware 15
- Energy saving tips 16
- Safety features 17
- Cleaning and care 18
- Frequently asked questions 20
- Technical Service 23
- IMPORTANT SAFETY INSTRUCTIONS 26
- Installation 29
- Electrical connection 39
- Gas connection 41
- Converting to another type of gas 44
- Help protect our environment 45
The burner does not ignite after several attempts.
Possible fault Solution
Disconnect the appliance from the electrical supply for a few seconds. If the
problem persists, check if:
–
The burner is assembled incorrectly.
–
The gas valve is closed.
–
The burner is wet and soiled.
–
The flame slits are dry and
unblocked
–
Reassemble the burner as shown in
"Cleaning and Care - Burners".
–
Open the gas valve.
–
Clean the burners. See "Cleaning
and Care".
–
Dry the igniters.
The flame goes out after being lit.
Possible fault Solution
The flames are not touching the ignition safety control. Check if:
– The burner is assembled incorrectly.
– There is no soiling on the ignition
safety control.
– Reassemble the burner as shown in
"Cleaning and Care - Burners".
– See "Cleaning and Care".
The flame appears different than usual.
Possible fault Solution
The burner is assembled incorrectly. Reassemble the burner as shown in
"Cleaning and Care - Burners".
The flame goes out during operation.
Possible fault Solution
The burner is assembled incorrectly. Reassemble the burner as shown in
"Cleaning and Care - Burners".
Frequently asked questions
21