Operating instructions/Installation instructions

Problem solving guide
38
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Messages in the display
Problem Cause and remedy
After the SmartLine ele-
ment has been
switched on or a sensor
control has been
touched,  appears in
the timer display for a
few seconds.
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
“System lock / Safety lock”).
After the SmartLine ele-
ment has been
switched on appears
in the timer display for a
short while. The Smart-
Line element does not
heat up.
The SmartLine element is in demonstration mode.
 Touch the0 and 2 sensor controls at the same
time until  flashes alternately with  in the
timer display.
The SmartLine element
has switched off auto-
matically. When the ele-
ment is switched back
on,  appears above the
On/Off sensor con-
trol.
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
 Clean off any dirt and/or remove the object (see
“Safety features” – “Safety switch-off”).
 flashes alternately
with  in the timer dis-
play and a tone will
sound.
The SmartLine element is connected incorrectly.
 Disconnect the SmartLine element from the mains.
 Contact Miele Service.
will flash alternately
within the timer
display.
The overheating protection mechanism has been ac-
tivated.
 See “Safety features – Overheating protection”.