Operating instructions/Installation instructions

Operation
22
Setting the power level – ex-
tended setting range
9 power levels are programmed at the
factory. If you wish to fine-tune a set-
ting, you can extend the power level
range to 17power levels (see “Pro-
gramming”).
 Touch the numerical keybank in
between two number sensors.
The numbers to the left and right of the
interim level light up brighter than the
other sensor controls.
Example:
if you have set power level 7. the num-
bers 7 and 8 will be brighter than the
other numbers.
Switching the heating ele-
ments on together
If you want to use the entire surface
with a single setting, the heating ele-
ments can be switched on and linked
together. The settings are controlled by
the front numerical keybank.
 Touch the sensor control.