Operating instructions/Installation instructions
Problem solving guide
46
Problem Cause and remedy
Power level 9 is auto-
matically reduced if you
select power level 9 on
two linked cooking
zones at the same time.
Operating both zones at power level 9 would exceed
the permitted maximum power for the two zones.
Use a different cooking zone.
The food in the pan
does not heat up when
the Auto heat-up func-
tion is switched on.
A large amount of food is being heated up.
Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
Use a different pot or pan which conducts heat
properly.
An operating noise can
be heard after the
SmartLine element has
been switched off.
The cooling fan runs until the SmartLine element
has cooled down and then switches off automatic-
ally.
The sensor controls
show increased sensit-
ivity or fail to react.
The sensitivity level of the sensor controls has
changed.
Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the Smart-
Line element. The area surrounding the SmartLine
element must not be too dark.
Take any pans off the SmartLine element and wipe
away any food deposits.
Ensure that there is nothing covering the entire
SmartLine element unit or sensor controls.
Interrupt the power supply to the SmartLine ele-
ment for approx. 1minute.
If the problem persists after power has been re-
stored, please contact Miele Service.
flashes alternately
with in the timer dis-
play and a tone will
sound.
The SmartLine element is connected incorrectly.
Disconnect the SmartLine element from the mains.
Contact Miele Service.
1 and a number, e.g. 1-0
flashes alternately with
a 3 digit number in the
timer display.
Cooking zone fault
Interrupt the power supply to the SmartLine ele-
ment for approx. 1minute.
If the problem persists after power has been re-
stored, please contact Miele Service.