Operating instructions/Installation instructions

Programming
38
You can adapt the programming of the
SmartLine element to your personal
needs. Several settings can be altered
in succession.
After accessing the programming
mode, the symbol and  will appear
in the timer display. After a few seconds
: (programme 01) will flash altern-
ately with : (code) in the timer dis-
play.
Changing the programming
Accessing programming mode
 With the SmartLine element
switched off, press and hold the
and sensor controls together until
the symbol lights up and is
shown in the timer display.
Setting the programme
For a two-digit programme number
you need to first set the tens position.
 Touch the sensor control re-
peatedly until the programme number
you want appears in the display, or
touch the appropriate number on the
numerical display.
Setting the code
 Touch the sensor control re-
peatedly until the code number you
want appears in the display, or touch
the appropriate number on the nu-
merical display.
Saving the settings
 While the programme is showing in
the display (e.g.:) touch the
sensor control until the indicators go
out.
To avoid saving the settings
 Touch the sensor control until the
indicators go out.