Operating instructions/Installation instructions

Connecting the Powerbrush to the
Electro Telescopic wand (see fig. 5)
^ Position the telescopic wand and
insert into the Powerbrush until it
clicks into place.
For more
information on the Use and
Care of the Powerbrush, see the
separate operating instructions.
Using the reversible floorhead
(depending on model)
Always follow the flooring
manufacturer's cleaning and care
instructions.
Connecting the reversible floorhead
to the Electro Telescopic
wand
(see fig. 6)
^ Fit the Electro Telescopic wand firmly
into the floor
head. Turn the wand in
opposite directions until it locks with
a click.
^ To release the Electro Telescopic
wand from
the floorhead press the
locking button (see arrow).
Adjusting the reversible floorhead
(see fig. 7)
To
clean carpets and rugs, lower the
bristles by
^
pressing the foot switch marked with
a %.
To clean hard flooring, raise the tool by
^ pressing the foot switch marked with
a ).
Always use the floorhead with the
bristles
raised to clean floors with
very deep joints or gaps.
Activating the exhaust filter change
indicator
Depending on the model, one of the
following standard exhaust filters is
installed (see fig. 8).
a AirClean Filter
b Active AirClean 50 Filter (black)
c HEPA AirClean 50 Filter (white)
^ Open the dust compartment lid and
raise until it clicks into place
(see fig. 9).
^ Remove the marker strip (see fig. 10).
^ Press the exhaust filter change
indicator ~ (see fig. 11).
^ After about 10-15 seconds, a small
red marker will appear in the
left-hand side of the display
(see fig. 12).
^ Close the dust compartment lid until
it clicks into place. Take care not to
catch the dustbag in the lid.
How the exhaust filter change
indicator works
The exhaust filter change indicator
displays the useful life of the exhaust
filter. The indicator will turn fully red
after approx. 50 hours of operation,
which is equivalent to one year of
average use (see fig. 13).
en
13